1.8 Inch TFT LCD Module 128 x 160
PROCEDURE
To Purchase Any Item, Press The " Add To Cart " Button Above and Then Continue Shopping. After Making Selections, View Your Cart On The Top Right Corner Of The Screen. Make Corrections If Any and Update Your Cart. Now You Can "Proceed To Check Out". Finally You Have To Press The " Place Order" Button. Now We Will Contact You.
DELIVERY AND RETURN POLICIES
1. Delivery Date and Delivery Charge Will Be Fixed, on Receiving The Customer Pin Code.
2. For Any Product Unsatisfaction, Please Report Within 7Days Of Delivery.
• Introductory Offer Price Displayed
• Model : 1.8 Inch TFT LCD Module 128 x 160
• PACKAGE: Quantity 1pc
• INSTRUCTIONS : Delicate equipment ' Handle with care′
• Please Observe The Module Carefully Before Placing The Order '
• https://www.mulberryonline.in
•B:13
•Display Size: 1.8″
•Driver IC: ST7735
•Input Voltage (V): 3.3 to
•5 Pixel Resolution: 128 x 160
•PCB Size (mm): 57×34 (LxW)
•Interface Type: SPI
•1.8-inch serial SPI colour display module
•Support analogue SPI and hardware SPI
•The LCD has a wide viewing angle, the contrast is also very suitable.
•Good quality display.
Description
This lovely little display breakout is the best way to add a small, colourful and bright display to any project. Since the 1.8 Inch TFT LCD Module display uses 4-wire SPI to communicate and has its own pixel-addressable frame buffer, it can be used with every kind of Microcontroller.
Even a very small one with low memory and few pins available! The 1.8″ display has 128×160 colour pixels. Unlike the low cost "Nokia 6110" and similar LCD displays, which are CSTN type and thus have poor colour and slow refresh, this display is a true TFT! The TFT driver (ST7735R) can display full 18-bit colour (262,144 shades!). And the LCD will always come with the same driver chip so there are no worries that your code will not work from one to the other.The breakout has the TFT display soldered on (it uses a delicate flex-circuit connector) as well as an ultra-low-dropout 3.3V regulator and a 3/5V level shifter so you can use it with 3.3V or 5V power and logic.We also had a little space so we placed a microSD card holder so you can easily load full-colour bitmaps from a FAT16/FAT32 formatted microSD card.
